Hello Dear Citizens. I want to appreciate every input I got in my self build project https://www.kobocity.com/d/80-first-time-owner-builder/349 from everyone here. Special thanks to @brabus . Appreciate you boss

Please I’m open as usual. Thanks in anticipation

Congratulations @tomaths on your new project. As you have started, you’ll surely finish it to your taste. I like the design and arrangement of the flats. No interference 💪. To solve cross ventilation issues at the middle flats, the building could have been splited at the middle (subject to availability of the space). Once again congrats. I’ll be following this discussion bumper to bumper.

mank1234 it’s actually 4 units of one bedroom downstairs and 2 units of 2 bedrooms and 1 unit of 1 bedroom upstairs

Dear elders, What’s the best approach to minimize wastage of planks on my site. Going by the work plan from my engineer, we should be casting the short pillers. Later on the casting of the long pillers then the lintel and decking. A carpenter suggested that I should buy the white wood and use it direct for the short pillers without cutting. As such the same will be useful for the long pillers and lintel. Engineer suggested we should outsource the whole process asking the carpenter to source for planks at each stage. He claimed no amount of planks bought now would be useful later on either for lintel or decking. Please elders, what is the best approach to this in other to avoid wastage at least upto the decking ? I wouldn’t like to invest so much in planks with my limited resources.

tomaths your engineer is right. Outsourcing is good but it can be disadvantageous too because most carpenters can’t guarantee good woods This can delay your project. I have and use dedicated steel forms or plywood formwork for short columns.

brabus Boss can we hire these things? What’s the cost implications compare to outright purchase?

tomaths what’s the height of your foundation wall? It’s considerably cheap to hire but it has a lot to do with the scope of the project. If it’s a project you’re pushing to slab level within 6 - 8 weeks, it makes sense to higher as we can provide these items at a reasonable cost to your project. but if it’ll take some time, the logistics cost (transportation etc) would make it unprofitable. if the engineer provides exactly what he need, we can provide shutters/formwork up to your slab level at a reasonable cost to you. Please note we do not give our formwork to other carpenters to use.

brabus the 6-8 weeks time frame is feasible and within the plan. The foundation wall is going to be between 5-6 coaches of blocks. The need according to the Engineer is the short pillar, long pillar, german floor, lintel, and decking. Can you give the cost estimate to the above, sir? Thanks always

New Project - Construction of 5 One Bedroom and 2 Two Bedroom Flats

tomaths

After we eventually cast the beam around the external foundation wall, german flor was done and now the setting began.

tomaths

We are here now, ready to commence the decking process.

tomaths

we are still here oo

tomaths

mank1234

tomaths the progress is impressive after just 2 months.

tomaths

Parapet casting done. Very much open to a roofing quotation. Any interested roofer should please reach out ASAP

tomaths

The roofing was completed.

« Previous Page